When people are sitting in the car ready to leave, but found that the engine can not start, this is a very annoying thing. But sometimes, unable to start the engine, just due to some small problems caused by, if you understand these reasons, understand these car repair basic knowledge can as soon as possible to solve the basic problem, this is only the most basic car repair knowledge, hope you can put these auto repair knowledge, to prevent their car out of the small problems can repair themselves.
First of all, to check the distributor, spark plug, high-voltage lines, etc. whether because of vehicle rain moisture, if so can the damp parts to dry, and then start.
Second, check the spark plug is damaged, if damaged, as long as the replacement of the new spark plug can be.
Third, check the battery voltage is enough. Sometimes, stop to turn off the lights, a long time, it is possible to run out of power. If so, the car hanging two block, foot clutch, vehicle drag (is generally not recommended, it is best to find people push), when traveling to a certain speed, release the clutch screwing the ignition switch (generally not recommended, should be before to push the ignition switch to on file), the car will be able to start. If there is a problem with the generator, this method does not work.
Engine stall when shifting
Moving in the shift, if the operating specifications, but the phenomenon of extinction, you need to check the following issues:
First look at idle speed is stable, idle is too low, if the idle speed is not stable or low idle, as long as the idle speed adjustment to the normal speed can be. Also tighten the idle stop valve, plug.
Secondly, if the idle speed is normal, it may be the carburetor is blocked, need to go to a professional repair station cleaning carburetor.
Steering wheel tremor at high speed
The car at high speed or at a higher speed when driving instability, the head, or even the steering wheel shake, the reasons for this situation are as follows:
1, front wheel alignment angle misalignment, before the beam is too large.
2, before the tire pressure is too low or tire due to repair and other reasons for starting the imbalance.
3, the front wheel radial deformation or the number of tire bolt.
4, transmission system parts installation loose.
5, drive shaft bending, dynamic unbalance, front axle deformation.
6, vibration damper failure